Salter-brecknell APD-100 Bedienungsanleitung PDF herunterladen (Seite 27)

APD-100 Automatic Powder Dispenser User Instructions 27

5.1 Setting Parameters

7. Type in a value between 1 and 100 and press the ENTER key to accept the

value displayed…

BEF. XX is displayed. Use this parameter to set the percent of the

weight at which the motor starts dispensing in pulse mode. XX is the

value of the setting. Settings are in percentages of the total powder

weight wanted for the charge so values can be between 1 and 100. The

default setting is 95.

This means the motor will run at pulse speed from the 95% weight level

to the 100% weight level.

Figure 5.3 Motor speed chart

8. Type in a value between 1 and 100 and press the ENTER key to accept the

value displayed…

ERRX.XX is displayed. This is an error parameter. Set this to an amount

between 0.3 grains (default) and 3.00 grains and when the scale is

finished auto-dispensing, if the weight on the scale varies from the

desired amount by more than this weight an ERROR message will

appear on the screen.

The equation below shows the relationship between the three parameters. CHG must

be less than or equal to SWI which must be less than or equal to BEF which must be

less than or equal to 100%.

CHG. XX <

SWI. XX < BEF. XX < 100%.

Also refer to the motor speed chart in Figure 5.3.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Keine Kommentare

Salter-brecknell APD-100 Bedienungsanleitung Seite 27